compcore_charts_2019-967x500.jpg

Bonding Agent
(use only bonding agents compatible with dual-cure composites, such as IntegraBond™)

1. Clean and dry prepared tooth surface.
2. Apply 37% phosphoric acid to the cavo surface for 10 to 15 seconds.
3. Rinse and dry cavo surface, do not desiccate the tooth.
4. Apply first coat of IntegraBond™ on prepared cavo surface. Allow to sit for 15 seconds, and then air dry.
Apply 2 to 3 more coats; without waiting, dry again after last application.
5. Light-cure for 20 seconds


Core Build-Up
1. Bleed syringe. Assemble intraoral tip to mix-tip, attach to syringe and bleed tip.
2. Place intraoral tip into the base of the prepared tooth and dispense. Let material rise around the tip while withdrawing to eliminate air bubbles.
3.Light-cure for 30 seconds. If the core is larger than 8mm, light-cure for at least an additional 10 seconds.*

Check for complete hardness. The preparation can be finished immediately. Alternately, the core can be chemical-cured, final set-time is 4.5 minutes.